Foonf/Fllo Drink-thingy Installation
Select side of seat cup holder will be installed on.
Locate slot on the underside of rear-facing belt path (left or right side of seat).
Insert tab on corresponding cup holder attachment.
Move opposite end of cup holder attachment into rear-facing belt path and press firmly to securely snap into place.
Slide the cup holder tab down into the securely mounted cup holder attachment.
NOTE: When the car seat is installed rear-facing with a vehicle belt, the cup holder can ONLY be used on the side closest to the seat belt buckle.
Foonf/Fllo Drink-thingy Removal
Remove seat cushion. See “Removing / Installing Seat Cushion” in your car seat manual.
Press bottom of cup holder tab and pull up to remove cup holder from attachment.
Press and hold inner tab on cupholder attachment.
While holding inner tab, use other hand from inside the seat to push cup holder attachment out of rear-facing belt path.
- It may be necessary to lift the bottom edge of the car seat cover to push the cup holder attachment out.
Remove cup holder attachment from car seat by sliding outer tab from slot on the underside of the rear-facing belt path.
Article is closed for comments.