Video Manual - Installing Liingo using UAS (LATCH) 

Step 1
Position Liingo on vehicle seat with child facing the rear of the vehicle, and rotate Carrier so that the blue Recline Reference Line is parallel with the ground.

Step 2
Open UAS (LATCH) Bin Door

Step 3
Press and hold red release button on each UAS Connector and pull out to remove from bin.

Step 4
Rotate UAS Bin Door up and push to close.

Step 5
Lengthen UAS belt by pressing and holding the adjuster release button while pulling belt to extend the length.

Step 6
Grasp the UAS connector that is furthest from the UAS belt adjuster and align with the UAS lower anchor located on the child’s right.

Step 7
With the red release button facing out, press the UAS Connector against the UAS lower anchor until you hear the click.

Step 8
Route UAS belt through both UAS/Lap belt guides and check that the UAS Belt is flat with no twists and properly positioned in both belt guides.

Step 9
Align UAS Connector closest to UAS Belt adjuster with the lower anchor located on the child’s left.

Step 10
With the red release button facing out, press the UAS Connector against the UAS lower anchor until you hear the click.

Step 11
Tighten UAS belt by using your body to press the carrier into the vehicle seat back while pulling free end of UAS belt to tighten

NOTE:
ALWAYS position Carrier so that the blue Recline Reference Line on side of Carrier is parallel with the ground.

If Carrier cannot be securely installed as instructed in this manual, try a different vehicle seating location or install Carrier using vehicle belt. See “Installing Car Seat with Vehicle Belt” in Liingo instruction manual.