How do I clean and care for my Oobr booster seat?

1. If the spot has dried, try lightly brushing or scraping off the residue. Wipe surface with water.
2. If a spot still remains, apply a solution of mild detergent and water to fabric with a light mist.
3. Work area using soft brush or edge of spoon from outside of spot towards the middle.
4. Allow solution to work for approximately one minute.
5. Remove with clean water or blot with clean soft towel.
6. Repeat steps 3-5 as necessary until spot is removed.
7. Rinse with clear lukewarm water and blot with clean soft white cloth as final step.
    

For non-Ziip models - Seat cushion cover only 
Remove seat cushion cover as shown in the below illustration.  

Note: backrest and headrest covers are not removable - these covers may be spot cleaned only. 
Once the seat cushion cover is removed, set aside the foam pad. DO NOT wash foam pad. Hand wash in solution of mild detergent and water, NO bleach. Rinse in clear water and hang to dry. Do NOT place in dryer. 
  
For Ziip models 
  
Remove seat cushion cover and unzip backrest cover (you may need to raise the headrest to access the full zipper. Note: Headrest cover is not removable and may only be spot cleaned as described in the first section above.   
 

Non-Mammoth Ziip fabrics are machine washable on gentle/ delicate cycle, dryable on low using non-bleach detergent only or can be spot cleaned using our cleaning kit. 
Mammoth Ziip is machine washable on gentle/ delicate cycle using wool-safe non-bleach detergent only; hang to dry or can be spot-cleaned using our cleaning kit. 
 

Use a soft cloth with warm water and mild soap. Apply light pressure with cloth in small circular motions. 
Do NOT soak or remove the labels from this car seat. They are meant to be permanent so they can remind you and others of important information. Removal will marr the finish of the seat.