How do I adjust a rear-facing Fllo's recline angle?

To increase the recline angle:

• Use the Anti-Rebound Bar to reposition the Fllo on the vehicle seat so that it is at the correct angle, then press down in the back of the seat cushion area while tightening the vehicle or UAS (LATCH) belt. A gap between the vehicle seat and the recline foot at the vehicle seat crease is permissible.
• A tightly rolled towel may be placed under the recline foot at the vehicle seat crease if needed to achieve the correct recline angle. Do NOT use pool noodles to adjust the recline angle as this may affect the stability of the installation.

To decrease the recline angle:

• Use the Anti-Rebound Bar to reposition the Fllo on the vehicle seat so that it is sitting more upright, then press down on the front edge of the seat cushion area while tightening the vehicle or UAS (LATCH) belt.
• Do NOT place anything between the angled portion of the base and the vehicle seat to obtain a more upright installation. The angled portion of the base MUST be in full contact with the vehicle seat without any overhang.

It is preferable to have infants under 22 lb more reclined, such that the upper reference line (infants under 22 lb) is parallel to the ground. However, providing that the ground-level falls within the Upper Reference Line for infants under 22 lb (40 degrees from vertical) and lower reference line for children 22lb and over (30 degrees from vertical), you may safely use the seat.