Video Manual - Installing Liingo using LATCH (UAS) 

Step 1
Position Liingo on vehicle seat with child facing the rear of the vehicle, and rotate Carrier so that the blue Recline Reference Line is parallel with the ground.

Step 2
Open LATCH Bin Door

Step 3
Press and hold red release button on each LATCH Connector and pull out to remove from bin.

Step 4
Rotate LATCH Bin Door up and push to close.

Step 5
Lengthen LATCH belt by pressing and holding the adjuster release button while pulling belt to extend the length.

Step 6
Grasp the LATCH connector that is furthest from the LATCH belt adjuster and align with the LATCH lower anchor located on the child’s right.

Step 7
With the red release button facing out, press the LATCH Connector against the LATCH lower anchor until you hear the click.

Step 8
Route LATCH belt through both LATCH/Lap belt guides and check that the LATCH Belt is flat with no twists and properly positioned in both belt guides.

Step 9
Align LATCH Connector closest to LATCH Belt adjuster with the lower anchor located on the child’s left.

Step 10
With the red release button facing out, press the LATCH Connector against the LATCH lower anchor until you hear the click.

Step 11
Tighten LATCH belt by using your body to press the carrier into the vehicle seat back while pulling free end of LATCH belt to tighten

NOTE:
ALWAYS position Carrier so that the blue Recline Reference Line on side of Carrier is parallel with the ground.

If Carrier cannot be securely installed as instructed in this manual, try a different vehicle seating location or install Carrier using vehicle belt. See “Installing Car Seat with Vehicle Belt” in Liingo instruction manual.