How do I properly adjust the Load Leg on the Liing base?

Step 1
Rotate the Load Leg out into the use position by pulling the Load Leg out from the Load Leg Storage on the bottom of the Base.

Step 2
Install the base using either the vehicle belt or the rigid LATCH (UAS) according to the instructions provided in the Liing manual.

• Installing Liing Car Seat Base (Canada)
• Installing Liing Car Seat Base (US)

Step 3
Once the base is securely installed, extend Load Leg and lock into position:

• Pull out and hold bottom of Load Leg Adjustment Handle.
• Grasp Load Leg and pull down to extend Load Leg until it touches the vehicle floor.
• Release Adjustment Handle and push down on Load Leg to lock into position.
• Confirm that Load Leg Pressure Indicator has turned from red to green.
• If Indicator remains red after the Load Leg has been locked into position, extend Load Leg one position further to increase the contact between the vehicle floor and the Load Leg.